2025-07-07

Merged a few pull requests, minor improvements, nothing big. Users can now configure if and when the button LEDs light up during use and during POVD.

General:

Added config options to make button LED brightness thresholds configurable. Battcheck -> 7H -> Options 3+4 now set the aux low/high ramp levels, for the brightness of the button while the main LEDs are on, and the brightness of Post-Off Voltage Display (POVD) after turning the main LEDs off. (may be options 2+3 on lights with no RGB aux, instead of 3+4) (new options are only available on lights with more than 8 KiB ROM)
Lockout mode now only does momentary moon/low on 1st and 2nd presses.
Documentation updates.
Fixed broken GitHub CI.

Hardware-specific changes:

&emisar-d3aa: Reduced moon preflash even more. If it still flashes, it probably can't be fixed in software.

Merged a few pull requests, minor improvements, nothing big. Users can now configure if and when the button LEDs light up during use and during POVD.

General:

Added config options to make button LED brightness thresholds configurable. Battcheck -> 7H -> Options 3+4 now set the aux low/high ramp levels, for the brightness of the button while the main LEDs are on, and the brightness of Post-Off Voltage Display (POVD) after turning the main LEDs off. (may be options 2+3 on lights with no RGB aux, instead of 3+4) (new options are only available on lights with more than 8 KiB ROM)
Lockout mode now only does momentary moon/low on 1st and 2nd presses.
Documentation updates.
Fixed broken GitHub CI.

Hardware-specific changes:

&emisar-d3aa: Reduced moon preflash even more. If it still flashes, it probably can't be fixed in software.

anduril