• Machine Support

  • CR-10 / S / Pro / S4 / S5 / Mini - closes #11
  • CR-20 / Pro
  • Ender 2 / 3 / 4 / 5 - closes #14, closes #37
  • Custom Machine

• Fixes and improvements

  • Not overriding old machines anymore (1) - closes #16, closes #7, closes #23, closes #28
  • Added machine settings to start g-code
  • Fixed Purge Line and moved to left border - closes #20
  • Fixed maximum retract Speed - closes #17
  • Fixed support Interface Z offset with Ultra/Super quality
  • Lowered support Interface Density (33.33%)
  • Disable bed adhesion when supports are enabled - closes #34
  • Lowered cooling initial height
  • Fixed More Nozzles size (0.3, 0.5, 1.0) - closes #5, closes #19, closes #31, closes #36
  • Fixed platforms size - closes #6
  • Fixed Dynamic Quality layer range
  • New splashscreen provided by @Guilouz - closes #12

Important notes: (1) Default machine definition are back available into the "Other" category when adding a machine. This allows to keep existing profiles usability in addition to CreawsomeMod ones. This should also avoid lot of issues when installing CreawsomeMod for the first time. However people upgrading from Beta 2 will need to reset the Cura installation. This is a last time required since CreawsomeMod now defines its own machines identifiers.