Unclaimed project
Are you a maintainer of rp2040-doom? Claim this project to take control of your public changelog and roadmap.
Changelog
Fully-featured Doom port for the Raspberry Pi RP2040 microcontroller
See The README for the latest info and more instructions including multiplayer wiring
NOTE: installing Doom will overwrite the contents of flash on your Badge. You should either back up the contents first, or just be prepared to download and re-flash the stock firmware later. Use...
NOTE: installing Doom will overwrite the contents of flash on your Badge. You should either back up the contents first, or just be prepared to download and re-flash the stock firmware later. Use this firmware at your own risk!!
Note you can install Doom on your badge by:
This is just a bit of fun, so not really planning to merge into RP2040 branch. Note the unicorn version (without rewriting all the drawing completely) adds quite a bit of code, so this only builds with Clang
To build with Clang, you need >1.5.0/develop of pico-sdk (and pico_extras), and pass -DPICO_COMPILER=pico_arm_clang, and `-DPICO_TOOLCHAIN_PATH=...
Initial Release
The attached binary will run on a Raspberry Pi Pico and contains the shareware DOOM1.WAD, and is built to match PICO_BOARD=vgaboard which has the following pins:
0-4: Red 0-5
6-10: Green 0-5
11-15: Blue 0-5
16: HSync
17: VSync
18: I2C1 SDA
19: I2C1 SCL
20: UART1 TX
21: UART1 RX
26: I2S DIN
27: I2S BCK
28:...